![]() This is the brightest of the White light color options. This is rarely seen in residential applications as the light output can seem a bit harsh and bright, and is most commonly seen in exterior or commercial applications. It is a 4000-4500K on the Kelvin Light Color Scale.ĭayWhite™ most closely replicates natural daylight and does have a slight blue hue to the light output. It puts out a pure white without any yellow undertone. It is a 2700-3000K on the Kelvin Light Color Scale.Ĭool White is equivalent to a standard CFL or Fluorescent light color and is most popular for commercial applications, although it is also used fairly often in residential. It has a slight warm yellow glow to it that many people find comfortable and we are all used to seeing in our homes. What light color should I choose? Warm White is equivalent to a standard incandescent light color and is most popular for residential applications. ![]() Have a question and don't see the answer below? Click here to chat with an LED expert. Can be hung from ceiling, mounted in ceiling or wall surfaces.Closet/storeroom/warehouse illumination. ![]() General office, reading and task lighting.Maintenance free and easy to install in existing fixtures.Aluminum alloy housing provides perfect heat management.No hazardous mercury or lead entering the environment.Major energy savings, reduction in power costs.Solid-state, high shock / vibration resistant.Remove the wrapped masking tape and your plastic panel is now ready for installation.32 degrees Fahrenheit (0 Celsius) to +113 degrees Fahrenheit (45 Celsius) Following the first cut made, turn to the other side of the panel until you completely remove it. Drag the knife down until you fully cover the first side of the panel. Begin by pressing the edge of the knife to the panel until the knife has penetrated the plastic. In between the edges of the masking tape, cut the panel using a knife. You can also ask someone to do this for you so that you can concentrate fully on the cutting of the plastic panel. Put one hand on the longer end of the plastic panel close to the mark and apply moderate pressure to keep it steady. Position the plastic panel on the table by putting the side that needs to be removed slightly over the table’s edge but not beyond the mark that you made. When cutting the plastic panel, work on an even surface or a flat work table. Also wrap it with masking tape around the other side of the line on the opposite end of the plastic panel. Make sure to tighten the rolling of the masking tape to give your plastic panel a firm hold on the tape. The mark that you made earlier serves as your guide. This can be accomplished by putting masking tape around the panel. Since the plastic panels are quite thin and break easily if not properly handled, it is best to keep the panel firm before cutting. To get a leveled measurement, place the straight edge on top of the panel to guide you on your marking. Using the marker, place the mark on the side of the panel with the smooth surface first, then continue doing the same to cover all sides. Once you have determined the necessary length of the panel that you need, mark this measurement on the plastic panel itself. Step 2 - Mark the Desired Length on the Plastic Panel So before you cut your lighting plastic panels, determine first the length that you will need in order to avoid wasting plastic panels. Since you will be covering the fixtures with lighting plastic panels, the size of the latter should also conform to the entire length of your fixtures.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |